• Montag, 25 November 2024
  • 02:16 Uhr Frankfurt
  • 01:16 Uhr London
  • 20:16 Uhr New York
  • 20:16 Uhr Toronto
  • 17:16 Uhr Vancouver
  • 12:16 Uhr Sydney

Abcourt Mines Inc.: Update of 43-101 Resources for Elder Mine and Tagami Property

25.04.2018  |  The Newswire
Mont-St-Hilaire, April 25, 2018 - Mr. Renaud Hinse, President and Chief Executive Officer of Abcourt Mines Inc. (TSX-V: ABI, Berlin: AML-BE and Frankfurt Stock Exchanges: AML-FF) ("Abcourt" or the "Company") is please to announce that a NI 43-101 update report of resources on the Elder mine has been prepared by Jean-Pierre Berube, engineer, independent consulting geologist and a Qualified Person according to NI 43-101, with pertinent experience in this domain. This update was done in three parts.

The first part is inside the limits of mining concession 363 and covers the upper part of the mine, from the 10th level to surface.

The second part covers the lower part of the mine, below the 10th level. This update was prepared for an application to have a mining lease.

The third part is located immediately to the North of the Elder mine and was incorporated in the 2012 calculations of resources.

See the cross-section below.


Click Image To View Full Size

At the Elder mine, the No. 1 vein is the main vein. It extends over a strike distance of about 650 meters, from surface to the bottom of the mine. The dip is 22o to the South. It is accompanied by vein #3 and #6 with the same strike and dip. There are also veins No.2 and No.2A, from the 4th level to surface, with the same strike and a dip of 40o S and vein No.4 with a North-South direction and a dip of 22o to the East. See the cross-section on the previous page.

Vein #7 is indicated in one hole with marginal values. Additional drilling will be done to assess the economic potential of this structure.

Abcourt owns 100% of the Elder and Tagami properties, made up of one mining concession, a mining lease, claims and small parts of claims for which a mining lease has been asked and adjacent claims.

Table of resources and parameters used

As of June 30, 2017, mineral resources in the measured and indicated categories, within the mining concession 363, in the upper part of the mine were as follows:

CATEGORIES

MEASURED

INDICATED

MEASURED + INDICATED

GOLD

ZONE

TONNES

GRADE

TONNES

GRADE

TONNES

GRADE

OUNCES

(Oz)

(metric)

(g/t)

(metric)

(g/t)

(metric)

(g/t)

ELDER

VEIN 1

8,091

6.00

111,146

7.60

119,237

7.49

28,727

VEIN 2

16,102

5.28

73,925

6.53

90,027

6.31

18,253

VEIN 3

5,200

8.23

37,942

6.21

43,142

6.46

8,954

VEIN 4

44,947

5.76

97,086

5.63

142,034

5.67

25,892

VEIN 6

0 0

71,711

7.71

71,711

7.71

17,768

TOTAL:

74,341

5.85

391,811

6.80

466,151

6.65

99,594


Measured and indicated resources on M.C. 363

In addition, inferred resources total 360,900 tonnes with a grade of 5.78 g/t Au.

CATEGORY

INFERRED

GOLD

ZONE

TONNES

GRADE

THICK

OUNCES

(Oz)

(metric)

(g/t)

(m)

ELDER

VEIN 1

102,600

5.32

2.08

17,544

VEIN 2

70,191

6.24

1.93

14,079

VEIN 3

64,258

6.17

2.18

12,749

VEIN 4

81,628

5.04

1.93

13,218

VEIN 6

42,227

6.97

1.81

9,460

TOTAL:

360,904

5.78

2.00

67,050

Inferred mineral resources within M.C 363

The technical parameters used were:

Density: 2.70 t/m3, minimum thickness: 1.8 m

Lower cutting grade = 3.45 g/t Au

Higher cutting grade = 31.1 g/t Au

RESOURCES LOCATED WITHIN MINING LEASE 1045

As of March 22, 2017, measures and indicated resources located within mining lease 1045 were as follows:

MEASURED

INDICATED

MEASURED+ INDICATED

GOLD

ZONE

TONNES

GRADE

THICK

TONNES

GRADE

THICK

TONNES

GRADE

THICK

OUNCES

(Oz)

(metric)

(g/t Au)

(m)

(metric)

(g/t Au)

(m)

(metric)

(g/t Au)

(m)

ELDER

Vein 1

230,217

7.66

5.18

51,030

5.01

2.13

281,247

7.18

4.63

64,916

CDR

-

-

-

4,172

16.49

2.50

4,172

16.49

2.50

2,213

TOTAL:

230,217

7.66

5.18

55,202

4.63

1.97

285,419

7.07

4.56

67,129

Measured and indicated resources within mining lease 1045

In addition, inferred resources totaled 94.088 tonnes with a grade of 5.15 g/t Au.

INFERRED

GOLD

ZONE

TONNES

GRADE

THICK

OUNCES

(OZ)

(mETRIC)

(g/t Au)

(m)

ELDER

Vein 1

43,840

5.14

2.49

7,246

CDR

50,248

5.15

1.83

8,328

TOTAL:

94,088

5.15

2.14

15,574

Inferred mineral resources in mining lease 1045

The technical parameters used for the calculation of these resources were the same as those used for the calculation of resources in the mining concession above.

TAGAMI RESOURCES LOCATED IMMEDIATELY TO THE NORTH OF THE ELDER MINE, NEAR SURFACE

In his 43-101 report of 2012, Jean-Pierre Berube estimated the Tagami resources. As there has not been any additional drilling since that time, these calculations are considered valid now.

CATEGORIES

MEASURED

INDICATED

MEASURED & INDICATED

GOLD OUNCES

ZONE

TONNES

GRADE

TONNES

GRADE

TONNES

GRADE

(metric)

(g/t Au)

(metric)

(g/t Au)

(metric)

(g/t Au)

(Oz)

TAGAMI

0 0

173,200

6.54

173,200

6.54

36,400

Indicated mineral resources at Tagami project (Berube 2012)

The parameters used for the calculation of these resources were the same as those above, except that the minimum thickness was 1.5 m instead of 1.8 m.

TOTAL RESOURCES OF THE ELDER MINE AND THE TAGAMI PROPERTY

The measured and indicated resources of the Elder mine and the Tagami property is shown in the table on the next page. These resources are estimated at 924,700 tonnes with a grade of 6.8 g/t Au, for a total of 200,000 ounces.

Categories

MEASURED

INDICATED

Zone

Tonnes

Grade

Ounces

Tonnes

Grade

Ounces

CM 363(1)

74,300

5.85

14,000

391,800

6.80

85,650

BM 1045

230,200

7.66

56,700

55,200

4.63

8,200

Projet Tagami

0

0,00

0

173,200

6.54

36,400

TOTAL:

304,500

7.22

70,700

620,200

6.53

130,250

Measured and indicated mineral resources for the Elder and Tagami properties

Note (1): From July 1, 2017, to March 31, 2018, Elder produced 82,450 tonnes with a grade of 4.41 g/t Au.

The inferred resources at Elder and Tagami is shown in the table below. These resources are estimated at 630,400 tonnes with a grade of 5.7 g/t Au, for a total of 114,800 ounces.

Category

INFERRED

Zone

Tonnes

Grade

Ounces

CM 363

360,900

5.78

67,100

BM 1045

94,100

5.15

15,600

Projet Tagami

175,400

5.69

32,100

TOTAL:

630,400

5.66

114,800

Inferred mineral resources for the Elder and Tagami properties

Quality control and assurance

In its operations, Abcourt applies a procedure for the three methods of sampling used: drill core (series D), chips (series F) and broken muck (series M), to reconcile grade with the ounces produced at the Sleeping Giant mill. The lab is directed by a chief analyst with adequate experience in this domain. This lab maintains an internal quality control program. Assay results of blanks, duplicates and standards appear regularly (3/24) on assay reports.

Check assays done for 15 chip samples (F) and 10 muck samples (M) done by an accredited laboratory (ALS-Chemex) indicate that the assay results from both laboratories have a very good coefficient of correlation (R2=0.975) even after including an odd value for sample M18465. See graph on next page.


Click Image To View Full Size

Strong correlation coefficient between Sleeping Giant (GD)

and ALS-Chemex (ALS) assays without the odd value

Marc Filion's resignation

It is with regrets that we announce the resignation of Marc Filion, as of March 2, 2018. The latter was a director and chief of finance for the Company. We wish to thank him for all the services rendered to the Company.

About Abcourt Mines Inc.

Abcourt Mines Inc. is a gold producer and a Canadian exploration company with strategically located properties in northwestern Quebec, Canada. The Elder property has gold resources (2012) and a positive P.E.A. study. Abcourt is focusing on the exploitation of the Elder mine.

The Abcourt-Barvue property has silver-zinc resources (2014). A feasibility study was completed in 2007 by Roche / Genivar on the Abcourt-Barvue project.

In 2016, Abcourt acquired the Sleeping Giant mine and mill, located half-way between Amos and Matagami, in Abitibi, Quebec, in the territory covered by the Plan Nord of the Quebec government. The mill has a capacity of 700 to 750 tonnes per day. Resources are being revised now.

To know more about Abcourt Mines Inc. (TSXV: ABI), please visit our web site at www.abcourt.com and consult our filings under Abcourt's profile on www.sedar.com.

This press release was prepared by Mr. Renaud Hinse, Engineer and President of Abcourt Mines Inc. and by Mr. Jean-Pierre Berube, independent engineer. Messrs. Hinse and Berube are "Qualified Persons" under the terms of Regulation 43-101.

Forward-Looking Statements

This news release contains forward-looking statements that include risks and uncertainties. When used in this news release, the words "estimate", "project", "anticipate", "expect", "intend", "believe", "hope", "may" and similar expressions, as well as "will", "shall" and other indications of future tense, are intended to identify forward-looking statements. The forward-looking statements are based on current expectations and apply only as of the date on which they are made. Except as may be required by law, the Corporation undertakes no obligation and disclaims any responsibility to publicly update or revise any forward-looking statements or information, whether as a result of new information, future events or otherwise.

The factors that could cause actual results to differ materially from those indicated in such forward-looking statements include changes in the prevailing price of gold, the Canadian-United States exchange rate, grade of ore mined and unforeseen difficulties in mining operations that could affect revenue and production costs. Other factors such as uncertainties regarding government regulations could also affect the results. Other risks may be set out in Abcourt' annual and periodic reports. The forward-looking information contained herein is made as of the date of this news release.

For more information, please contact:

Renaud Hinse, President and CEO

T: 819 768-2857 450 446-5511

F: 819 768-5475 450 446-3550

Email: rhinse@abcourt.com

Neither TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.

Copyright (c) 2018 TheNewswire - All rights reserved.

Bewerten 
A A A
PDF Versenden Drucken

Für den Inhalt des Beitrages ist allein der Autor verantwortlich bzw. die aufgeführte Quelle. Bild- oder Filmrechte liegen beim Autor/Quelle bzw. bei der vom ihm benannten Quelle. Bei Übersetzungen können Fehler nicht ausgeschlossen werden. Der vertretene Standpunkt eines Autors spiegelt generell nicht die Meinung des Webseiten-Betreibers wieder. Mittels der Veröffentlichung will dieser lediglich ein pluralistisches Meinungsbild darstellen. Direkte oder indirekte Aussagen in einem Beitrag stellen keinerlei Aufforderung zum Kauf-/Verkauf von Wertpapieren dar. Wir wehren uns gegen jede Form von Hass, Diskriminierung und Verletzung der Menschenwürde. Beachten Sie bitte auch unsere AGB/Disclaimer!



Mineninfo
Abcourt Mines Inc.
Bergbau
862198
CA00288E3005
Copyright © Minenportal.de 2006-2024 | MinenPortal.de ist eine Marke von GoldSeiten.de und Mitglied der GoldSeiten Mediengruppe
Alle Angaben ohne Gewähr! Es wird keinerlei Haftung für die Richtigkeit der Angaben und der Kurse übernommen!
Informationen zur Zeitverzögerung der Kursdaten und Börsenbedingungen. Kursdaten: Data Supplied by BSB-Software.