Group Eleven Extends Zone 1 Mineralized Trend by 30m and Intersects Zinc Mineralization 750m to NW of Zone 1 at Carrickittle Zinc Prospect, PG West Project
![Group Eleven Extends Zone 1 Mineralized Trend by 30m and Intersects Zinc Mineralization 750m to NW of Zone 1 at Carrickittle Zinc Prospect, PG West Project](https://www.minenportal.de/media/goldseiten-news.jpg)
Highlights:
- At Carrickittle, G11-2840-26 extended mineralization at Zone 1 by 30m (to 130m) to the NW, intersecting 9.33m of 0.48% Zn+Pb and 8.1 g/t Ag (true width 81%), including: (a) a narrow high-grade zone (0.10m of 20.0% Zn+Pb and 6.6 g/t Ag) and (b) a separate Cu-Ag bearing zone (2.77m of 0.10% Cu, 20.4 g/t Ag and 0.40% Zn+Pb, including 0.91m of 0.17% Cu, 37.6 g/t Ag and 0.41% Zn+Pb)
- Although narrower than the massive sulphides recently intercepted at Zone 1 (e.g. 7.2m of 30.5% Zn+Pb and 108 g/t Ag2), the above intercept is approximately ten times wider (at similar grades) than the nearest pierce point along the modelled lens (0.91m of 0.51% Zn+Pb in historic hole P21)
- Follow-up drilling is in the planning stages to test the possibility of mineralization widening further towards the NW in an un-drilled area approximately 750m by 950m, immediately north of Zone 1
- Three other holes drilled over 750m to the NW from Zone 1 returned encouraging results (local zinc mineralization in bedrock, suspected highly-weathered residuals of Zn-Pb mineralization and black-matrix breccia) despite not being able to directly test the target horizon due to significant karst cavities and faulting (with one hole lost mid-way due to excessive cavities)
- The above results corroborate the presence of massive sulphide mineralization intersected in nearby historic drilling (12.1m of intermittent sphalerite and galena bearing veins, hosting 0.77m of 7.79% Zn+Pb and 15.4 g/t Ag, including 0.07m of 61.3% Zn+Pb and 107.0 g/t Ag, located in the upper wall of a 2.4m cavity in hole 2840/9), suggest more high-grade mineralization may be in close proximity
- At Tullacondra, the Company recently completed a 144.5m-long hole (G11-3535-01; see news release dated February 2, 2022 for background details); assays expected over the next 3-6 weeks
"Along with our extension of Zone 1 by 30% to a strike of 130m, our northerly holes add further evidence that the mineralizing system seen at Zones 1-4 likely continues NW and beyond," stated Bart Jaworski, CEO. "This justifies our recent move to start drilling at the Carrickittle North and West prospects1. Meanwhile, a large and prospective 950m x 750m area remains undrilled at the centre of the Carrickittle prospect. We look forward to testing this zone in the next few months, with a view to finding a wider 'blow-out' of Zone 1. Separately, our ongoing drilling at the Stonepark JV is progressing on schedule and we look forward to starting our drill program at Ballywire in the coming weeks. With two rigs and over 6,000m of drilling planned this year, 2022 is poised to be our busiest year to date."
Location of Tullacondra and Carrickittle Prospects at and near PG West Project (100% interest), Ireland
The Carrickittle prospect is located within the PG West Project (100%-interest), located in SW Ireland, approximately 10kms along the Pallas Green Corridor from Glencore's Pallas Green zinc deposit3 ("Pallas Green", see Exhibit 1). The Tullacondra Cu-Ag prospect is located approx. 20km south of PG West.
Carrickittle - Drill Results from First Pass Drilling at the 1km NW Extension
Carrickittle represents one of the key vectors informing the Company's on-going drilling at the south-side of the Limerick Volcanic Complex. As previously reported, drilling at the NW Extension at the Carrickittle prospect was completed mid-December 2021, comprising four shallow holes (see Exhibit 2), totalling 727 metres. This represents the Company's first drill campaign at the NW Extension. Assay results from the laboratory were delayed due to Covid-19 related issues. This was the Company's first drill campaign at the NW Extension.
G11-2840-26 extended mineralization at Zone 1 by 30m (to 130m) along strike, intersecting 9.33m of 0.48% Zn+Pb and 8.1 g/t Ag (true width estimated to be 81%), including: (a) a narrow high-grade zone (0.10m of 20.0% Zn+Pb and 6.6 g/t Ag) and (b) a Cu-Ag zone (2.77m of 0.10% Cu, 20.4 g/t Ag and 0.40% Zn+Pb, including 0.91m of 0.17% Cu, 37.6 g/t Ag and 0.41% Zn+Pb).
Although weaker than the massive sulphides recently intercepted at Zone 1 (e.g., 7.2m of 30.5% Zn+Pb and 108 g/t Ag2), the above intercept is approximately ten times wider (at similar grades) versus the next nearest pierce point along the modelled lens (0.91m of 0.51% Zn+Pb in historic hole P21; see Exhibit 3). The above intercept also occurs on-trend as predicted, adding further confidence to Group Eleven's exploration model. Follow-up drilling is being finalized to test the possibility of mineralization widening further towards the NW in an un-drilled area measuring approximately 750m by 950m, immediately north of Zone 1 (see Exhibit 2).
Two holes (G11-2840-27 and -28) were drilled in the NW portion of the Carrickittle prospect, approximately 750m NW of Zone 1 (see Exhibit 2). This locality was drilled historically (in 2000) yielding a 12.1m zone of intermittent sphalerite and galena bearing veins, including a zone of clay and massive sulphide which averaged 0.77m of 7.79% Zn+Pb and 15.4 g/t Ag, including 0.07m of 61.3% Zn+Pb and 107.0 g/t Ag, located in the upper wall of a 2.4m cavity (historic hole 2840/9). Historic hole 2840/10, drilled approx. 100m to the NW, intersected a 2.95m zone with intermittent sphalerite and galena veinlets (not assayed). Importantly, both historic holes had large (7.8m and 1.7m, respectively) cavities at the base of the Waulsortian limestone and hence, the target horizon remained untested.
Exhibit 4. Summary of Recent Drill Results from Carrickittle 1km NW Extension, PG West, Ireland
Hole ID | From | Int | Zn | Pb | Zn+Pb | Ag | Cu | Comment |
m | m | % | % | % | ppm | % | ||
G11-2840-26 | 78.93 | 9.33 | 0.366 | 0.112 | 0.478 | 6.8 | 0.031 | WL Lmst |
incl | 82.30 | 0.10 | 18.900 | 1.100 | 20.000 | 6.6 | 0.021 | WL Lmst and dyke |
and | 85.49 | 2.77 | 0.209 | 0.195 | 0.404 | 20.4 | 0.100 | WL Lmst |
incl | 86.37 | 0.91 | 0.266 | 0.141 | 0.407 | 37.6 | 0.166 | WL Lmst |
G11-2840-27 | 161.45 | 1.15 | 0.522 | 0.089 | 0.611 | 0.7 | 0.001 | WL Lmst dol |
" | 175.50 | 1.10 | 0.164 | 0.028 | 0.193 | 0.8 | 0.010 | Karst Clay |
G11-2840-28 | 49.00 | 0.80 | 0.048 | 0.001 | 0.049 | 0.2 | 0.007 | Karst Clay (1 of 8) |
G11-2840-29 | - | - | - | - | - | - | Volc vent, WL Lmst |
Note: True width of hole -26 is estimated at 81%, whereas for holes -27 and -28, true widths are unknown; "WL Lmst" means |
The aim of Group Eleven's drilling in this locality was to drill in the vicinity of the above historic holes and test the base of the Waulsortian limestone (target horizon), while also assessing the nature of the prominent NW-trending magnetic-high anomaly in this area (see Exhibit 2).
G11-2840-27, drilled in between the two historic holes, returned 1.15m of 0.61% Zn+Pb in dolomitized Waulsortian limestone approximately 10-15m above the target horizon. A number of cavities were encountered in the hole and specifically, a large (5-10m) cavity was encountered at the base of the Waulsortian limestone (target horizon), similar to historic drilling. Sampling of residual clays recovered from this cavity returned very anomalous Zn+Pb levels (1.10m of 1926 ppm, including 0.60m of 2,035 ppm) suggesting mineralization was likely present before being weathered out in-situ.
G11-2840-28, drilled 50m SE of historic drilling, encountered an even higher number of cavities (with recoveries averaging only 45%), resulting in the loss of the hole at 113.5m (vs. anticipated target horizon at 200m). Samples collected across the recovered karst clays returned anomalous Zn+Pb levels (300-495 ppm). It is unclear if higher Zn+Pb levels (similar to G11-2840-27) would be observed in cavities closer to the target horizon (i.e., if the hole was completed). Despite not being completed, G11-2840-28 definitively shows the large mag-high feature on the west of this target area reflects karstic Waulsortian limestone. It is unclear if karst is spatially related (i.e., via preferential weathering) to mineralization in this area.
Despite not being able to directly test the target horizon, the above two holes are encouraging given they corroborate the presence of massive sulphide mineralization intersected in nearby historic drilling and suggest more high-grade mineralization may be in close proximity. Further work would be needed outside of the magnetic-high anomaly (i.e., outside the karst field; see Exhibit 2) in order to test for better-preserved zinc mineralization.
The fourth hole (G11-2840-29) was drilled by Group Eleven testing a circular magnetic-high feature (see Exhibit 2). The hole confirmed the presence of a volcanic vent and intersected a highly-brecciated and locally pyrite-rich package of Waulsortian limestone, including black-matrix breccia ("BMB", an important pathfinder for zinc in Ireland). The BMB intersected is similar to BMBs observed at the Company's Stonepark zinc deposit4, located 10km to the NW. The base of the Waulsortian limestone was faulted with approximately 20m of underlying lithologies removed, suggesting the hole was only a partial test of the target horizon.
Overall, this hole implies that the circular magnetic-high features located at the north side of the Carrickittle prospect (see Exhibit 2), likely represent volcanic vents. Given they seem to generally occur along a broad EW trending belt across the prospect, suggests a structural zone parallel to the southern edge of the Limerick Volcanic Complex. This structural zone is likely to be prospective for zinc mineralization, especially towards the north.
Quality Assurance/Quality Control (QA/QC) Information
Group Eleven inserts certified reference materials ("CRMs" or "Standards") as well as blank material, to its sample stream as part of its industry-standard QA/QC programme. The QC results have been reviewed by the Qualified Person, who is satisfied that all of the results are within acceptable parameters.
Qualified Person
Technical information in this news release has been approved by Paul Gordon, P.Geo., geological consultant at SLR Consulting, and independent 'Qualified Person' as defined under Canadian National Instrument 43-101.
About Group Eleven Resources
Group Eleven Resources Corp. (TSX.V: ZNG; OTC: GRLVF and FRA: 3GE) is a mineral exploration company focused on advanced stage zinc exploration in Ireland. Additional information about the Company is available at www.groupelevenresources.com.
ON BEHALF OF THE BOARD OF DIRECTORS
Bart Jaworski, P.Geo.
Chief Executive Officer
Neither TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.
Cautionary Note Regarding Forward-Looking Information
This press release contains forward-looking statements within the meaning of applicable securities legislation. Such statements include, without limitation, statements regarding the future results of operations, performance and achievements of the Company, including the timing, content, cost and results of proposed work programs, the discovery and delineation of mineral deposits/resources/ reserves and geological interpretations. Although the Company believes that such statements are reasonable, it can give no assurance that such expectations will prove to be correct. Forward-looking statements are typically identified by words such as: believe, expect, anticipate, intend, estimate, postulate and similar expressions, or are those, which, by their nature, refer to future events. The Company cautions investors that any forward-looking statements by the Company are not guarantees of future results or performance, and that actual results may differ materially from those in forward looking statements as a result of various factors, including, but not limited to, variations in the nature, quality and quantity of any mineral deposits that may be located. All of the Company's public disclosure filings may be accessed via www.sedar.com and readers are urged to review these materials, including the technical reports filed with respect to the Company's mineral properties.
1 See News Release by Group Eleven dated January 19, 2022 | |
2 See News Release by Group Eleven dated December 9, 2020 | |
3 Resources and Reserves Report (Glencore, December 31, 2020) - 45.4 million tonnes of 7% Zn + 1% Pb (Inferred) | |
4 Stonepark MRE: please refer to the NI 43-101 Independent Report on the Zinc-Lead Exploration Project at
|
SOURCE Group Eleven Resources Corp.<
Contact
E: b.jaworski@groupelevenresources.com, T: +353-85-833-2463; E: s.heinrichs@groupelevenresources.com, T: +604-630-8839