Westward Gold Comments on Completion of Inaugural Drill Campaign & Next Steps

Drill Campaign - Overview

In total, the Company completed ~3,850 meters of reverse-circulation drilling across 13 holes and 4 target zones, all of which were outside of the footprint of the historical resource estimate at Toiyabe (~173 koz at 1.2 g Au/t)(1) (the "Historical Estimate"). Drillhole depths ranged from a minimum of 244 meters to a maximum of 349 meters, with an average depth of 296 meters; for comparison, only 16% of all holes identified from previous operators' campaigns(2) reached a depth of +180 meters.

Colin Moore, CEO of Westward, commented: "On behalf of Westward management and the Board of Directors, I would like to extend our deepest thanks to Dave Browning (VP Exploration), Savannah Reyes (Project Geologist) and Steven Koehler (Technical Advisor) for their tireless efforts executing a safe and efficient drill campaign. This represents a very significant milestone for the Company, and a vital step in the continued advancement of our Nevada land package."

Figure 1: (Left to Right) - Colin Moore (CEO), Steven Koehler (Advisor), Richard Bedell (Advisor)
and Savannah Reyes (Project Geologist) Looking at Drill Cuttings from Rig (June 2022)

Click Image To View Full Size

Drill Campaign - Primary Goals & New Theses Tested

The main goals of the Company's first drill campaign at Toiyabe were threefold:

• Prove out the lateral extent of mineralization at Toiyabe outside of the Historical Estimate footprint, as a step towards potential future resource expansion (See Figures 2 through 4)

• Test a major deformation zone / blind thrust fault (the "SSD Zone"), identified through relogging of previous drillholes, 3D modeling, and hyperspectral core imaging. Drilling was also designed to test the Company's thesis that the SSD Zone dips to the northeast from its surface expression at the past-producing Toiyabe-Saddle open pits (contrary to legacy modeling) (See Figure 3)

• Test a newly-discovered and previously-undrilled target, the Toiyabe Hills Fault (the "TH Fault"); this important structural feature / fluid pathway may have played a key role in mineral deposition in the area (including at the Toiyabe-Saddle Mine immediately south along the fault trace) (See Figure 4)

SSD Zone: The deformation zone was encountered at a depth which suggests the Company's thesis was correct; preliminary modeling shows that the interpreted dip angle (to the northeast) lines up with the few legacy holes drilled deep enough to reach the SSD Zone underneath the Historical Estimate (those intersections were +25 meters wide with grades of +1 g Au/t(2)). This target area also included the deepest hole in Westward's campaign (T2211 - 349 meters; see Figure 2 below), with the technical team making the decision to go deeper than anticipated with holes T2211 and T2210 based on favourable real-time observations; large sections of oxidation, decalcification and intrusive rocks were encountered throughout the length of the holes.

TH Fault: Drilling confirmed the presence of this previously-unknown structural feature, as well as several other structures encountered across the holes in the target zone. Broad zones of decalcification (+15 meters) and intrusive rocks were observed throughout the drilling; surface mapping and drill cuttings confirmed that the TH Fault was a fluid conduit based on the alteration and intrusive rocks.

Dave Browning, VP Exploration, noted: "The confirmation of the TH Fault, and our thesis as it relates to the geometry of the SSD Zone, will lead to a much more robust geological and structural model at Toiyabe. This in turn could point us to some exciting follow-up targets based on our much-improved understanding of mineralization controls at Toiyabe."

Figure 2: Drill Testing the California Target Area

Click Image To View Full Size

Figure 3: Drill Testing the SSD Zone at the Toiyabe-Saddle Down-dip Target Area

Click Image To View Full Size

Figure 4: Drill Testing the TH Fault at the Toiyabe Hills North & South Target Areas

Click Image To View Full Size

Next Steps

The Company's technical team has begun its initial post-campaign analyses, which will include logging of all the completed holes, and a fulsome update to the 3D model. Data pertaining to mineralization will be incorporated into the model as assays are received. Along with fire assays / ICP (Au - ICP21) for gold mineralization, ALS Ltd. will also be testing for a full 48-element suite with four acid / ICP-MS (ME-MS61). To Westward's knowledge, this will be the first drill campaign at Toiyabe to do so.

(1) Source: NI 43-101 Technical Report, American Consolidated Minerals Corp., Prepared by Paul D. Noland, P. Geo., May 27, 2009 (the "2009 Technical Report"). A qualified person has not done sufficient work to classify the Historical Estimate at Toiyabe as current mineral resources and Westward is not treating the Historical Estimate on Toiyabe as a current mineral resource, as defined in National Instrument 43-101 - Standards of Disclosure for Mineral Projects ("NI 43-101"). The Historical Estimate was calculated using mining industry standard practices for estimating Mineral Resource and Mineral Reserves (2005) which was prior to the implementation of the current CIM standards for mineral resource estimation (as defined by the CIM Definition Standard on Mineral Resources and Ore Reserves dated May 10, 2014). The key assumptions, parameters and methods used to prepare the Historical Estimate on Toiyabe are described in the 2009 Technical Report. While Westward considers the Historical Estimate on Toiyabe disclosed in this news release to be relevant to investors, it cautions readers that it should not be unduly relied upon in drawing inferences on the mineralization on Toiyabe, as additional work is required to upgrade or verify the Historical Estimate as a current mineral resource. This additional work includes (but may not be limited to): re-sampling and re-assaying of available core and/or pulps, verification of assay certificates and digital assay data, verification of select drill hole collars, review and verification of drill hole geologic logs versus the preserved core and RC cuttings, incorporation of AuCN assays to provide a general understanding of metallurgical characteristics, review and verification of mineralization controls and modelling techniques.

(2) Sources: NI 43-101 Technical Report, IM Exploration Inc., Prepared by Donald E. Cameron, P.Geo., August 5, 2021; Toiyabe data room and drill log files inherited from previous operators. The Company and its qualified person have relied on third-party data during its review of the information presented herein, and while it believes the information to be relevant to investors, it cautions readers that it should not be unduly relied upon in drawing inferences on the mineralization at Toiyabe, as additional work is required to confirm drill intercepts and/or soil samples, including (but not limited to): re-sampling and re-assaying of available core and/or pulps, verification of assay certificates where available, review and verification of drillhole geologic logs versus the preserved core and RC cuttings.

Qualified Person

The technical information contained in this news release was reviewed and approved by Steven R. Koehler, Technical Advisor to the Company, who is a Qualified Person under National Instrument 43-101 - Standards of Disclosure for Mineral Projects. Mr. Koehler is a Certified Professional Geologist (CPG) through the American Institute of Professional Geologists (AIPG).

About Westward Gold

Westward Gold is a mineral exploration company focused on developing the Toiyabe, Turquoise Canyon, and East Saddle Projects located in the Cortez Hills area of Lander County, Nevada. From time to time, the Company may also evaluate the acquisition of other mineral exploration assets and opportunities.

For further information contact:

Colin Moore
President, CEO & Director
Westward Gold Inc.
colin@westwardgold.com
Tel: +1 (647) 403 0391

www.westwardgold.com

The Canadian Securities Exchange has neither approved nor disapproved the contents of this news release. The Canadian Securities Exchange does not accept responsibility for the adequacy or accuracy of this news release.

This news release contains or incorporates by reference "forward-looking statements" and "forward-looking information" as defined under applicable Canadian securities legislation. All statements, other than statements of historical fact, which address events, results, outcomes, or developments that the Company expects to occur are, or may be deemed, to be, forward-looking statements. Forward-looking statements are generally, but not always, identified by the use of forward-looking terminology such as "expect", "believe", "anticipate", "intend", "estimate", "potential", "on track", "forecast", "budget", "target", "outlook", "continue", "plan" or variations of such words and phrases and similar expressions or statements that certain actions, events or results "may", "could", "would", "might" or "will" be taken, occur or be achieved or the negative connotation of such terms.

Such statements include, but may not be limited to, information as to strategy, plans or future financial or operating performance, such as the Company's expansion plans, project timelines, expected drilling targets, and other statements that express management's expectations or estimates of future plans and performance.

Forward-looking statements or information are subject to a variety of known and unknown risks, uncertainties and other factors that could cause actual events or results to differ from those reflected in the forward-looking statements or information, including, without limitation, the need for additional capital by the Company through financings, and the risk that such funds may not be raised; the speculative nature of exploration and the stages of the Company's properties; the effect of changes in commodity prices; regulatory risks that development of the Company's material properties will not be acceptable for social, environmental or other reasons, availability of equipment (including drills) and personnel to carry out work programs, that each stage of work will be completed within expected time frames, that current geological models and interpretations prove correct, the results of ongoing work programs may lead to a change of exploration priorities, and the efforts and abilities of the senior management team. This list is not exhaustive of the factors that may affect any of the Company's forward-looking statements or information. These and other factors may cause the Company to change its exploration and work programs, not proceed with work programs, or change the timing or order of planned work programs. Additional risk factors and details with respect to risk factors that may affect the Company's ability to achieve the expectations set forth in the forward-looking statements contained in this news release are set out in the Company's latest management discussion and analysis under "Risks and Uncertainties", which is available under the Company's SEDAR profile at www.sedar.com. Although the Company has attempted to identify important factors that could cause actual results to differ materially, there may be other factors that cause results not to be as anticipated, estimated, described or intended. Accordingly, readers should not place undue reliance on forward-looking statements or information. The Company's forward-looking statements and information are based on the assumptions, beliefs, expectations, and opinions of management as of the date of this press release, and other than as required by applicable securities laws, the Company does not assume any obligation to update forward-looking statements and information if circumstances or management's assumptions, beliefs, expectations or opinions should change, or changes in any other events affecting such statements or information.